bovington tank museum Archives - Page 18 of 20

Marmon-Herrington Mark VI Armoured Car

This Marmon-Herrington Mark VI Armoured Car was on display at Bovington Tank Museum.

The Marmon-Herrington Armoured Car was a series of armoured vehicles that were produced in South Africa and adopted by the British Army during the Second World War. RAF Armoured Car companies possessed them, but seem never to have used them in action.

The Mark VI was a return to the 8-wheeled design. Powered by two Mercury V8 engines with an eight-wheel drive steered on the front and rear wheels. Two prototypes were built, one with a 2 pounder and other with a 6 pounder gun in an open-topped three-man turret with electric powered traverse and protected by 10 to 30 mm of sloped armour. Additional armament consisted of 2 or 3 machine guns. The two-pounder equipped version was sent to the UK for assessment, the transmission proved unreliable suffering several axle failures. The 2-pdr is now in the Bovington Tank Museum, the other in South Africa.

Light Tank Mk II

This, hidden in the darkness of the Tank Museum is the Light Tank Mk II.

Here is a photograph of the same tank, taken ten years earlier, painted in a brown camouflage pattern.

Only sixty vehicles were produced.

M14/41 Medium Tank

The M 14/41 was a four-crew medium tank that served from 1941 in the Royal Italian Army.

This M14/41 Medium Tank was on display at the Tank Museum in Bovington.

Captured versions of the M14/41 Medium Tank were used by British and Australian troops in the desert.

I do like the Italian tanks for World War Two and have thought about building a 15mm force using them, along with the P40 Heavy Tank Mid-War Monster.

Centurion Mk I

One tank that did interest me at Bovington was the Centurion Mk I.

The Centurion was the primary British main battle tank of the post-Second World War period. Introduced in 1945, it is widely considered to be one of the most successful post-war tank designs, remaining in production into the 1960s, and seeing combat in the front lines into the 1980s.

Development of the Centurion began in 1943 with manufacture beginning in January 1945. Six prototypes arrived in Belgium less than a month after the war in Europe ended in May 1945, so too late to see action.

Of course in any alternative history scenario where the war continued after May 1945 in Europe, the Centurion Mk I would have seen action. Likewise in a another alternative history scenario where either Stalin decided to press West after defeating Nazi Germany to take over Western Europe, or the Western Allies decided to “liberate” Eastern Europe from the yoke of Stalin’s communist oppression, again the Centurion Mk I would have seen action.

I remember when Battlefront put up the details about their 15mm Australian Mk5 Centurion for Vietnam. I wrote the following thought:

My first thought when I saw the Centurion Mk5 was how close was it to the early versions, could I get away with using it for my Late War British forces in say a 1946 scenario? Only a handful of Mk1s were made when in November 1945 the Mk2 started coming off the production lines. The Mk3 did not enter production until 1948, so for a 1946 scenario, it would be the Mk2. The main difference between the Mk5 and the Mk2 would the main weapon, with the Mk5 having the L7 105mm gun, whilst the 1945 version had the QF 20 pdr. Though it would appear from the Battlefront site that the Australian Army Centurions were armed with the QF 20 pdr.

Simon in a comment in response, said:

Nice thought, but too many differences. For a start, different turret shape: no bustle, smaller, different-shaped stowage bins. No long-range fuel tank on the back, completely different engine deck. The ANZAC Mk V had a 105mm gun, the 20pdr had no fume-extractor and no muzzle-brake. These are just off the top of my head! However, if it’s a what-if scenario, who cares?

You can now get a 15mm Centurion MkI from Butlers’ Printed Models.

Ah the wonders of 3D printing.

The Centurion actually first first entered combat with the British Army in the Korean War in 1950, in support of the UN forces.

Carro Veloce L3/33

The Carro Veloce 33 or L3/33 was a tankette originally built in 1933 and used by the Italian Army before and during World War II. It was based on the imported British Carden Loyd tankette.

This Carro Veloce L3/33 was on display at the Bovington Tank Museum.

This is the flamethrower variant, which was captured in North Africa. It carried 500 litres of flame fuel in a special trailer (which you can see behind the tankette). The flame fuel was delivered by a pump, driven off the gearbox, which gave it a flaming range of about 35 metres. However crews were warned not to use the flamethrower when travelling at full speed (26mph) as they might set themselves alight.

There is no evidence that they were used in battle One of the things I find seeing these kinds of armoured vehicle in the “flesh” is how small they are. I am surprised anyone can sit in that let alone two crew. It must be really cramped and having the flamer fuel pumped through the centre of the tankette, wouldn’t be surprised by the reluctance of these being used.

A34 Comet Tank

Within the Tank Museum at Bovington is the A34 Comet Tank.

The Comet was was a British cruiser tank that first saw use near the end of the second world war. It was designed as an improvement on the earlier Cromwell tank, mounting the new 77 mm HV gun in a new lower profile and part-cast turret. This gun was effective against late-war German tanks, including the Panther at medium range, and the Tiger.

The Comet saw action in the closing stages of World War II and remained in British service until 1958, but was rapidly eclipsed by Centurion. In some cases, Comets sold to other countries continued to operate into the 1980s.

I do have some of the Flames of War plastic models, but they are still currently still in their boxes. I have been thinking of using them not only for Late War Flames of War games, but also 1950s Cold War games. The Comet remained in British service until 1958. Reading the Hot War books from Harry Turtledove has inspired me to think about gaming some scenarios from the books. British Comets and Centurions versus Russians T34-85 and T54 Soviet tanks with American M26 Pershing and M48 Patton tanks. In the book there are also Sherman manned by (West) German forces.

Why such a liking for this tank, well, as with other models, I suspect that it was because I bought and made the Matchbox Comet many, many years ago.

Peerless Armoured Car

A rather dark photograph of mine of the Peerless Armoured Car at the Bovington Tank Museum.

During the First World War, sixteen American Peerless trucks were modified by the British to serve as armoured cars. These were relatively primitive designs with open backs, armed with a Pom-pom gun and a machine gun, and were delivered to the British army in 1915.

After the war, a new design was needed to replace armoured cars that had been worn out. As a result, the Peerless Armoured Car design was developed in 1919. It was based on the chassis of the Peerless three ton lorry, with an armoured body built by the Austin Motor Company.

Here is a better lit photograph of the Peerless Armoured Car at Bovington from Wikimedia.

Poor off-road performance hampered the vehicle but it still saw considerable service, notably in Ireland. A few were still in service with the British at the start of the Second World War. Seven were in service with the Irish National Army during the Irish Civil War and used by the Irish Defence Forces up until 1932.

This photo appeared in the Sunday Independent on 13 August 1922, with the caption: “A Dangerous Corner – This photograph was taken in one of the towns captured during the past week by the National Army. It shows an amoured car “manoeuvring for position” at the end of a street facing the post office. Irregulars occupy the further end of the street, and are being quickly dislodged by infantry supported by the armoured car.”

Peerless Armoured Car in Cork in 1922 – National Library of Ireland on The Commons [No restrictions]

These armoured cars would have been used in the world of A Very British Civil War. They would also make ideal vehicles for the concept of the 1919 British Revolution I talked about in this blog post.

Vickers A1E1 Independent Tank

This is the Vickers A1E1 Independent a the Tank Museum which alas wasn’t very well lit, but I have added a further official photograph below.

The Independent A1E1 is a multi-turreted tank that was designed by the British armaments manufacturer Vickers between the First and Second World Wars. Although it only ever reached the prototype stage and only a single example was built, it influenced many other tank designs.

The A1E1 design can be seen as a possible influence on the Soviet T-100 and T-28 tanks, the German Neubaufahrzeug tanks, and the British Medium Mk III and Cruiser Mk I (triple turret) tank designs. The Soviet T-35 tank was heavily influenced by its design.

Vickers A1E1 Independent — Photograph KID 109 from the collections of the Imperial War Museums (collection no. 6000-02)

Though never developed beyond the prototype stage, you can imagine that it might have entered production if the Second World War had started earlier, or we had the potential scenario of A Very British Civil War.

The tank was the subject of industrial and political espionage, the plans ending up in the Soviet Union, where they may have influenced the design of the T-28 and T-35 tanks.

There are lots of skirmish games or role playing scenarios that could be inspired by this. Soviet agents, aided by communist sympathisers, attempt to break into the Vickers factory to steal the plans (or even the prototype) and British police, the Security Services and even troops attempt to stop them.

Warhorse Tank

The Tank Museum obtained the tank used in Steven Spielberg’s World War One blockbuster Warhorse. Here is a photo I took when I was at the museum in 2016.

Though it looks like an authentic Mark IV tank, it was in fact constructed for the film.

Here is a video about the “tank” at the Tank Museum .

Mark VIII “The International” Tank

This Mark VIII “The International” Tank was on display at Bovington Tank Museum. It is the last remaining survivor of the six Mark VIII tanks which were completed for Britain.

When the United States declared war on Germany in 1917 the US Army started to look at tanks. They favoured the American Renault as their light tank but used British Mark V and Mark V* tanks for their heavy battalion. However they had their own ideas on tank design and, in co-operation with the British Tank Corps came up with a new heavy tank design for 1919.

The Mark VIII tank also known as the Liberty or The International was an Anglo-American tank design of the First World War intended to overcome the limitations of the earlier British designs and be a collaborative effort to equip France, the UK and the US with a single heavy tank design.

Production at a site in France was expected to take advantage of US industrial capacity to produce the automotive elements, with the UK producing the armoured hulls and armament. The planned production levels would have equipped the Allied armies with a very large tank force that would have broken through the German defensive positions in the planned offensive for 1919. In practice manufacture was slow and only a few vehicles were produced before the end of the war in November 1918.

Many people have thought that the tank used in the Indiana Jones and the Last Crusade film was a Mark VIII. However that tank was specially created for the film, inspired though somewhat by the Mark VIII.

Mechanical effects supervisor George Gibbs said this movie was the most difficult one of his career. He visited a museum to negotiate renting a small French World War I tank, but decided he wanted to make one. The tank was based on the tank Mark VIII, which was thirty-six feet (eleven meters) long, and weighed twenty-five tons. Gibbs built the tank over the framework of a twenty-five ton excavator, and added 6.4 ton tracks, that were driven by two automatic hydraulic pumps, each connected to a Range Rover V8 engine. Gibbs built the tank from steel, rather than aluminum or fiberglass, because it would allow the realistically suspensionless vehicle to endure the rocky surfaces. Unlike its historical counterpart, which had only the two side guns, the tank had a turret gun added as well. It took four months to build, and was transported to Almería on a Short Belfast plane, and then a low loader truck.

I had meant to buy what I thought was a Copplestone Castings’ Mark IX Beast, a similar model of the Indiana Jones tank, but it appeared that it was no longer manufactured or sold by North Star Figures.

It's not. It was never Copplestones, it belonged to HLBSCo, but I think they sold the whole range to another company. Sorry can't help more.

— NorthStarFigs (@NorthStarFigs) November 12, 2019

So it appeared that it wasn’t even a Copplestones Castings, but was by the Honourable Lead Boiler Suit Company (HLBSCo).

Sometimes you should buy things when you see them and not wait…

So it was originally designed and manufactured by the Honourable Lead Boiler Suit Company (HLBSCo) they were small and relatively new. I even remember discussing licensing the models for a commercial version of Tally Ho!

So I did some searching on the Google and found that the tank is available today with the other HLBSCo models from Empress Miniatures.