Having done some background reading and looking at other models I have started work on my Ork Looted Rhino.
Having taken on all these various versions I decided on a particular course of action. I would redo the side doors, the front panel, the rear door. I would also redo the top door and try and make a variant or two which could jsut slot into place. I wouldn’t have a roller, but would use one of the Chaos spikey front ends. I decided to use the Chaos Havoc Launcher with a Killa Kan and use the supplied Burna with the Rhino.
The first thing I decided to do was change the front left panel. So I removed the rivets and the other protruding plastic.
I then stuck down a piece of plasticard to which I added three panels and a covering strip. These were glued together using plastic cement glue. I then added Orky rivets using sliced plastic rod and stuck down with super glue.
I then added a door again using plasticard with plastic strip for the hinge and supporting struts. I also thought that the panels looked too new so I hacked them about with a sharp knife. I also hacked some of the Rhino structure as well.
This is a close-up of the front left panel.
More soon.